Home : Use stuff : Unusual uses : Bottles : Drill holster


Comment on this tip

Bottles Drill holster

Submitted by Sean

To make a portable carrier for a cordless drill or screwdriver, cut the neck off a plastic bottle. Then cut it again about halfway down the bottle on the diagonal. You can either screw the carrier to the wall above your workbench or cut two slits in the taller side and thread it onto a belt.



The tips, hints and ideas at TipKing are vetted prior to publishing however some methods remain speculative in their own nature; therefore the information should be used responsibly and at your own discretion. The Information is displayed on an "As Is" basis, without warranty. Full disclaimer

Page copy protected against web site content infringement by Copyscape
Ask a question Send in a tip Contact TipKing Books Privacy Disclaimer Feed
© Tipking 2000-2011 All rights reserved Last update: Thu Nov 17 2011
 
| privacy